SUPER SEAL 25 VT

SUPER SEAL VT is a Low VOC, styrene-acrylic copolymer solution formulated to achieve both a protective and decorative finish as well as allow the concrete to attain full mix design properties.

SUPER SEAL VT is a film-forming sealer, which will assist the curing of
freshly placed concrete. SUPER SEAL VT is formulated as follows:
SUPER SEAL-25 VT: Available in Clear & Brown tinted. Slow drying, High solids (25%) formulation for spray-ability. Two coats of
SUPER SEAL-25 VT are preferred to one thick coat. A better Low VOC formulation than the competition.

• High Gloss, Matte, and Brown tinted for exposed pea gravel

• 25% Styrene Acrylic Concrete Sealer/Curing Aid

• Solvent-based Concrete Cure and Sealer

• Slower drying No acetone

• Great for most types of concrete

• A wet look enhances the color of decorative concrete

• Not for cured broom-finished concrete

• ASTM 1315 & 309

• <350 g/L meets low VOC standards of OTC & LADCO

• Low VOC-regulated states include: the District of Columbia, RI, ME, NJ, VA, MA, NH, VT, and Maricopa County (AZ)

• Available in 1-gallon cans, 5-gallon pails, & 55-gallon drums

FEATURES

• High Gloss
• Wet Look
• High Solids
• U.V. Resistant
• Slower Drying
• Easy to Spray

PREPARATION

Clean dirt, wax, grease, oil and other contaminants from the surface. Be sure to remove any foreign coating unless previous coating is
same or similar solvent-based sealer. Make sure the surface is clean, dry and sound. Clean oily concrete with Clemons’ CLEANER
DEGREASER. Use a bristle brush for heavily oiled spots. If surface is slick, etch with Clemons’ ETCH & CLEAN. Rinse well with a
pressure washer. Allow 24 hours to dry. Apply only when surface and air temperatures are above 50° F and below 90° F. Do not apply
to excessively hot surfaces as rapid drying may cause bubbles to form. For pavers, sweep away any loose sand.

APPLICATION

When applying to fresh concrete, wait until all bleed water has evaporated. For best results apply SUPER SEAL VT with a solventresistant sprayer. Hold conical spray tip no more than 8” from surface. If product must be rolled be sure to use a solvent-resistant nonshedding roller cover. Use a long nap roller for exposed aggregate, a medium nap roller for textured surfaces and a short nap roller for
smooth surfaces. Keep roller soaked by dipping on every stroke. Every few feet turn perpendicular to the first coat, and cross roll
without re-dipping. Wait until the surface is tack-free before applying a second coat. The continual dipping with the first coat gives a
heavy application and the cross-rolling allows for an even application. Clean up immediately with aromatic solvent such as A-1 Solvent
or Xylene. Do not thin product. Foot traffic should be avoided for 4 hours. Vehicle traffic should be avoided for 48-72 hours. Cooler
temperatures or increased humidity will slow the dry.